Are you the one who needs to know the exact ways of utilizing a Router Table? Here are a few guidelines to get the maximum results from your router table.
If you are employing a miter channel, then the fence must be square to the same. Why face that trouble when you can create a jig to glide along with the Fence? You can make the adjustment in the profile and depth of cut. A Router Lift makes this simple. A top quality Router Table Fence also eases the collection of dust. Use your Router Table and Fence for simplicity and ease! You should never put your wood piece in between the fence and the router bit. That is just inviting trouble for you.
With an anti-climb cut, you make virtually all the cuts that way. If terribly careful, you can go a little distance in the other direction. Make sure you do less than 15% of your work this way. You need to only make shallow or light cuts.
Don’t take massive cuts. Do these only when your hands are guarded and away from the router bit. The center edge-to-edge joint technique can be used for making solid tabletops, wide panels, or perhaps make edging to go round your router table top.
How can we guarantee a focused edge? Firstly, decide on the tongue dimensions. You have got a slot cutter. You would like the tongue thickness to be less than two times the cut hence the tongue thickness is less than “. We employ a ” depth of cut for this example.
We would like to use a tongue that is less than 0.5″ in thickness. We all know that the rabbet on the Table Top is barely more than 5 / 16″ on each side of a 1 1 / eight” thick piece. Rabbet the crown edge with a rabbet routing bit and a bearing to supply a quarter ” rabbet. You don’t want to take a lot during your first pass. Therefore, the depth of cut is set for 1 / 8″ for your first pass. Set the fence in such a manner that it is even with the bearing of the rabbet bit. Cut both the top and bottom of the top. Take some time and go all of the ways around for precision.
Ensure that your wood piece lies flat on the Router Table Top. Or you can also use the router on top of your wood piece. Measure the thickness of the tongue. If it is larger than half “, then simply adjust the depth of cut. A router lift makes this straightforward.
NOTE: You rout both the sides, so use one-half the adjustment for each side. The tongue’s thickness is now barely less than half “. Replace your rabbet bit with your ” slot cutter. You can also disconnect the energy source to the router before changing bits to be safe! Make the rabbet piece sit on the router tabletop near the slot cutter.
Raise your Router so the base of the slot cutter aligns with the base of the tongue. You could need support if the wood piece is gigantic. Initially, set the depth of the cut for the slot to round about three / sixteen”. Now start to slot your Oak edging. Turn it over and slot it again. Test the slot on the tongue. Only lower your slot bit by 0.5 of the dimension, if needed.
Since the slot cut is quarter “, the second pass is not going to use the whole cutter. Once the slot (groove) fits on the tongue, you are all geared up to set your last depth of the groove. The final depth of cut is slightly more than 0.25″ to allow for gluing. Set your fence according to this final depth. Remember – make 2 passes with the help of the slot. This gives you a finished fit. You can use this technique for any edge-to-edge joinery. For example Tabletops, panels, large drawer fronts, or for anything that you need to join two pieces.
There you go! You get an accurate placement and a solid joint.