ROUTING YOUR WAYS OF POSSIBILITIES

One of the most flexible and significantly used motor powered tools for any woodwork needs has to be a ROUTER. This tool is capable of doing so many things; you might spend an enormous amount of time and money learning their actual potential. There are a number of things to keep in mind when buying a ROUTER.

ROUTING YOUR WAYS OF POSSIBILITIES
1) The first thing is to decide if you’re counting on owning more than one of these modern wonders. For most of the professional woodworkers, dedicated routers are very common.
Routers simply mean the cutters also known as the bits. These are set to perform certain functions. Routers are not utilized for anything else once altered for doing a specific task. Clearly, a home woodwork shop is not as likely to own ten or even more routers; yet having more than one is an excellent idea.
2) If you would like to install one into a router table, it is very convenient to have a dedicated one. Generally, you would need a plunge router for this and one with an acceptable power to handle bigger cutter sets. For example, raised panel cutters for making cupboard doors. One important tip is always to remember that router safety is critical while these tools are considered relatively safe yet they can do a lot of damage.
3)Using the correct feed direction is important, whether in a hand held router or with a router table. With a router table, feeding a wood piece to a spinning router bit, in the same direction that the bit is turning, is likely to finish up with the board being pulled out of your hands and shot like a missile across your shop.
If that piece hits somebody, there’s a very powerful chance that it will be deadly. Just perfectly memorize that the feed direction in a handheld router is left to right and in a router table is right to left. The feed direction is always opposite, since the router is held in the opposite position.
4)Keep in mind that the eye protection is a must. Also, a mask for the dust is highly recommended. One tool that may fill the air around you with too much of dust is the router. If your router has a vacuum port, it significantly helps. Some routers also have a toggle type switch, so it’s important to verify that the switch is off before plugging the vacuum port.
It’s very crucial to hold a router with both hands when turning on the switch, as the torque in these tools can lead you to lose control of it. So it’s best to have the router held flat onto the working surface, with the bit not coming in contact with the board, and then turning it on. Gently bring the router in contact with the work piece.
5)Getting the best results from a router is dependent upon a few basic things. Sharpness of the bit and the feed rate are fundamentals.
Moving the router too slow will result in burn marks on the board. And moving the router too fast, will not just put pointless strain on the motor, bit will also end up in a poor cut.
The best feed rate takes some experimenting, and is obviously different for numerous woods and diverse router bits.

Hence, the learning curve for employing a router is relatively low for the fundamental use, but with all the possibilities this tool provides, you can spend a considerable quantity of time mastering your imagination and creativity.

Author: Joshua Johnson

I’m Joshua Johnson. I am a professional woodworker, furniture & tool designer. Like humans even machines have their levels of control, so here on this website, reviews of the Best and Top 5 Router Tables lets you decide which one would you be able to work with and converge the human energies and that of a machine into a masterpiece.

Share This Post On

Submit a Comment

Your email address will not be published. Required fields are marked *